HP Designjet 8000 HP Designjet 8000s Printer Series - User's Guide - Page 150
Other messages
![]() |
View all HP Designjet 8000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 150 highlights
Solution: load media. See How do I load/unload media. Problem: you have set an invalid media size (less than 297 mm wide or 64 inch wide or more). Solution: set the correct size. See How do I load/unload media. Problem: there is media skew. Solution: reload the media (see How do I load/unload media). Skew may be caused by ink deposits on the platen. Check the platen for ink deposits and clean any ink. See How do I maintain the printer. Problem: the media lever has not been lowered. Solution: lower the media lever. Error LED is flashing Problem: the take-up reel is not winding the media correctly. Solution: check that the media is correctly detected by the take-up reel sensor. Check that the media is loaded correctly. See How do I... Use the take-up reel. Other messages Problem: the cover is open. Solution: close the cover. The problem is... (troubleshooting topics) Problem: the temperature of the printheads exceeds the operating temperature range. Solution: allow the printheads to cool by not using the printer until the printhead temperature returns to the operating temperature range. 140 Chapter 8 The problem is... (troubleshooting topics) ENWW
![](/manual_guide/products/hewlettpackard-designjet-8000-hp-designjet-8000s-printer-series-users-guide-2b25fa1/150.png)