HP Designjet 9000s Service Manual - Page 107
Install Done, The Printer does not recognize the Heater Control Panel.
View all HP Designjet 9000s manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 107 highlights
Maintenance Mode 6 Power Off the Printer and power it On again and check the Heater firmware version once the Printer has initialized ⇒ Page 4-50. The following messages could appear during the Heater firmware upgrade procedure: The Printer does not recognize the Heater Control Panel. HEATER PANEL ERR POWER OFF/ON - Try powering Off the Printer and On again and retry the firmware upgrade procedure. If the message continues to appear after rebooting several times, then replace the Heater Panel ⇒ Page 8-27. There is a problem with the IC Card. IC CARD ERROR POWER OFF/ON - Check that the IC Card contains the actual firmware image. - Make sure that the IC Card is inserted into the Main PCA correctly. - Try powering Off the Printer and On again and retry the firmware upgrade procedure. If the message continues to appear after rebooting several times, then replace the Heater Panel ⇒ Page 8-27. There is a communication problem between the Main PCA and the Heater Panel. DATA ERROR POWER OFF/ON - Try powering Off the Printer and On again and retry the firmware upgrade procedure. If the message continues to appear after rebooting several times, then replace the Heater Panel ⇒ Page 8-27. The upgrade procedure cannot be performed because the Heater firmware has been deleted. WRITING ERROR POWER OFF/ON - Replace the Heater Panel ⇒ Page 8-27. Install Done This option allows you to indicate whether the Printer Installation has been performed correctly so that the preventive maintenance counters can activated: 1 In the Setup submenu, scroll to "Install Done" and press the OK key. # INSTALL DONE > NO HP Designjet 9000s Series Printer Service Manual 4-51