HP Designjet 9000s Service Manual - Page 20
Boot-Up Error, Problem, Description, Corrective Action
View all HP Designjet 9000s manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 20 highlights
System Error Codes Boot-Up Error: Internal RAM (0001) Problem Description: The read/write of the RAM on the Main PCA was diagnosed and an error was detected. Corrective Action: Try the following: Replace the Main PCA ⇒ Page 8-35. Boot-Up Error: SRAM (0002) Problem Description: The read/write of the SRAM on the Main PCA was diagnosed and an error was detected. Corrective Action: Try the following: Replace the Main PCA ⇒ Page 8-35. Boot-Up Error: Flash ROM (0004) Problem Description: The program area in the Flash ROM is sum-checked, and it could not be read, causing an error. Corrective Action: Try the following: Reinstall the Firmware (Printer and Boot Firmware). If the Error continues, replace the Main PCA ⇒ Page 8-35. Boot-Up Error: PIO (0008) Problem Description: The read/write of a specific Parallel I/O (PIO) was tested and an error was detected. Corrective Action: Try the following: Replace the Main PCA ⇒ Page 8-35. Boot-Up Error: NVRAM (0010) Problem Description: Problems with the NVRAM detected. Corrective Action: Try the following: If multiple errors have occurred that include the NVRAM error, try to resolve the other errors first. After resolving the other errors (except NVRAM), switch the Printer Off. Switch the Printer On again and only the NVRAM error recovery will be performed. If System Error Code 11Ax appears when the Printer is turned On, then refer to Page 2-10. Replace NVRAM ⇒ Page 8-39. Replace Main PCA ⇒ Page 8-35. 2-4 HP Designjet 9000s Series Printer Service Manual