HP Designjet 9000s Service Manual - Page 169

Adjustments and Calibrations Capping Position Calibration This calibration must be performed whenever: „ Capping Station is disassembled or replaced. „ Capping Unit is disassembled or replaced. Perform the Capping Position Calibration as follows: 1 Enter into the Maintenance Mode ⇒ Page 4-7. 2 Move the Carriage Assembly to the Capping Station (if not already at the Capping Station) ⇒ Page 4-18. 3 If the Printheads are capped, uncap them ⇒ Page 4-43. 4 Enter into the "Cap Position" Menu ⇒ Page 4-13. # CAP POSITION > +0.0 mm This adjustment must be performed when the Printheads have been uncapped. Do NOT move the Carriage when the Printheads are capped as this could damage the Printheads. 5 Visually check that the center of the Capping Units are aligned with the center of the Printheads. Printhead Capping Unit 6 If the center of the Capping Units are not aligned with the center of the Printheads, you will need to visually estimate the deviation between the Capping Units and the Printheads. Measure deviation HP Designjet 9000s Series Printer Service Manual 5-25