HP ENVY x2 - 13-j012dx HP ENVY x2 (model numbers 13- j000 through 13-j099) Mai - Page 36

Remove the Phillips PM1.9×3.3 screw

Get HP ENVY x2 - 13-j012dx PDF manuals and user guides View all HP ENVY x2 - 13-j012dx manuals
Add to My Manuals
Save this manual to your list of manuals

Page 36 highlights

1. Disconnect the WLAN antenna cables (1) from the WLAN module terminals. NOTE: The #1/white WLAN antenna cable connects to the WLAN module #1/Main terminal. The #2/black WLAN antenna cable connects to the WLAN module #1/Aux terminal. 2. Remove the Phillips PM1.9×3.3 screw (2) that secures the WLAN module to the base enclosure. (The WLAN module tilts up.) 3. Remove the WLAN module (3) by pulling the module away from the slot at an angle. NOTE: If the WLAN antenna cable is not connected to a WLAN module terminal, a protective sleeve should be installed on the antenna connector, as shown in the following illustration. Reverse this procedure to install the vibrator module. 30 Chapter 5 Removal and replacement procedures

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
1.
Disconnect the WLAN antenna cables
(1)
from the WLAN module terminals.
NOTE:
The #1/white WLAN antenna cable connects to the WLAN module #1/Main terminal.
The #2/black WLAN antenna cable connects to the WLAN module #1/Aux terminal.
2.
Remove the Phillips PM1.9×3.3 screw
(2)
that secures the WLAN module to the base enclosure.
(The WLAN module tilts up.)
3.
Remove the WLAN module
(3)
by pulling the module away from the slot at an angle.
NOTE:
If the WLAN antenna cable is not connected to a WLAN module terminal, a protective sleeve
should be installed on the antenna connector, as shown in the following illustration.
Reverse this procedure to install the vibrator module.
30
Chapter 5
Removal and replacement procedures