HP Elite 7100 Maintenance & Service Guide: HP Elite 7100 Series Microtower - Page 56
Removing a 3.5-inch Device Media Card Reader Shown, Disconnecting the Media Card Reader Cable
View all HP Elite 7100 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 56 highlights
4. Disconnect the USB cable from the system board. Figure 7-21 Disconnecting the Media Card Reader Cable 5. Remove the two retainer screws that secure the reader to the bay (1) then slide the reader forward and out of the bay (2). Figure 7-22 Removing a 3.5-inch Device (Media Card Reader Shown) NOTE: To install an external 3.5-inch drive, refer to Installing a Drive into the 3.5-inch External Drive Bay on page 49. 48 Chapter 7 Removal and Replacement Procedures Microtower (MT) Chassis
4.
Disconnect the USB cable from the system board.
Figure 7-21
Disconnecting the Media Card Reader Cable
5.
Remove the two retainer screws that secure the reader to the bay
(1)
then slide the reader
forward and out of the bay
(2)
.
Figure 7-22
Removing a 3.5-inch Device (Media Card Reader Shown)
NOTE:
To install an external 3.5-inch drive, refer to
Installing a Drive into the 3.5-inch External Drive
Bay
on page
49
.
48
Chapter 7
Removal and Replacement Procedures Microtower (MT) Chassis