HP Elite 7100 Maintenance & Service Guide: HP Elite 7100 Series Microtower - Page 72
System Board
View all HP Elite 7100 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 72 highlights
System Board When replacing the system board, be sure that the following components are removed from the defective system board and installed on the replacement system board: ● Memory modules ● Processor ● Expansion cards To remove the system board: 1. Prepare the computer for disassembly (Preparation for Disassembly on page 28). 2. Remove the access panel (Access Panel on page 29). 3. Lay the computer on its side with the rear facing toward you. 4. Remove the front bezel (Front Bezel on page 30). 5. Remove an expansion cards (Expansion Cards on page 36). 6. Disconnect the power, and data cables from the back of all installed drives. 7. Disconnect all cables from the system board. 8. Remove the eight screws that secure the system board to the chassis. 9. Slide the system board toward the front of the chassis, and then lift it up and out of the chassis. 64 Chapter 7 Removal and Replacement Procedures Microtower (MT) Chassis