HP EliteBook 755 Maintenance and Service Guide - Page 77
Display assembly, and the camera cable
View all HP EliteBook 755 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 77 highlights
Display assembly NOTE: Display assemblies are spared at the subcomponent level only. Additional display assembly spare part information is available at Display assembly subcomponents on page 25. Before removing the display assembly, follow these steps: 1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the computer on, and then shut it down through the operating system. 2. Disconnect all external devices connected to the computer. 3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet, and then unplugging the AC adapter from the computer. 4. Remove the bottom cover (see Bottom cover on page 34). 5. Disconnect the battery cable from the system board (see Battery on page 47). Remove the display assembly: 1. Disconnect the antenna cables from the WWAN module (1) and the WLAN module (2). 2. Remove the antenna cables from the clips built into the computer (3). 3. Disconnect the display cable (4) and the camera cable (5) from the system board. 4. Remove the cables from the clips built into the computer (6). 5. With the computer upside down, open the display, and then place the computer on a table with the display positioned off the edge of the table. 6. Remove the five Phillips M2.5×5.0 screws (1) from the display hinges. Component replacement procedures 67