HP Integrity rx2800 Boot from SAN Guide - Page 21
Booting Windows Server 2003 and Windows Server X64 edition systems from a storage area network
View all HP Integrity rx2800 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 21 highlights
Figure 12 Single server, one dual-channel HBA, two switches, cross-cable HA storage configuration . Booting Windows Server 2003 and Windows Server X64 edition systems from a storage area network SCSIport miniport and Storport miniport driver support for Boot from SAN configurations HP supports the SCSIport miniport and Storport miniport driver for Windows Server 2003 and the Storport miniport driver on Windows server 2008. For boot from SAN configuration and driver information about the SCSIport miniport and the Storport miniport drivers, go to the HP SAN Infrastructure website http://h18006.www1.hp.com/storage/saninfrastructure.html. Boot from SAN procedures The following integrated procedure can be used to configure systems to boot from SAN-based storage using either Emulex or QLogic HBAs and EVA, or XP arrays. This procedure can be used in c-Class blade configurations using Virtual Connect (VC) and its optional centralized management functionality to define boot path information for each Boot from SAN blade server. Several of the steps pertain only to Virtual Connect-managed Boot from SAN configurations. You can also use this procedure to set up non-VC or non VC-managed Boot from SAN configurations. Be sure to follow all the steps in the order presented, unless you are specifically directed to skip steps for your configuration. Step 1 - Set up the system hardware - basic Refer to the documentation provided with your hardware to perform the following steps. Fibre Channel host bus adapters software guide for Windows 21