HP J4899B User Manual - Page 31

Connect the Switch to a Power Source, Horizontal Surface Mounting

Get HP J4899B PDF manuals and user guides View all HP J4899B manuals
Add to My Manuals
Save this manual to your list of manuals

Page 31 highlights

Caution Installing the Switch 2650 Installation Procedures Horizontal Surface Mounting Place the switch on a table or other horizontal surface. The switch comes with rubber feet in the accessory kit that can be used to help keep the switch from sliding on the surface. Attach the rubber feet to the four corners on the bottom of the switch within the embossed angled lines. Use a sturdy surface in an uncluttered area. You may want to secure the networking cables and switch power cord to the table leg or other part of the surface structure to help prevent tripping over the cords. Make sure the air flow is not restricted around the sides and back of the switch. 5. Connect the Switch to a Power Source 1. Plug the included power cord into the switch's power connector and into a nearby AC power source. 2. Re-check the LEDs during self test. See "LED Behavior" on page 2-9. Installing the Switch 2650 2-15

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
  • 83
  • 84
  • 85
  • 86
2-15
Installing the Switch 2650
Installation Procedures
Installing the Switch 2650
Horizontal Surface Mounting
Place the switch on a table or other horizontal surface. The switch comes with
rubber feet in the accessory kit that can be used to help keep the switch from
sliding on the surface.
Attach the rubber feet to the four corners on the bottom of the switch within
the embossed angled lines. Use a sturdy surface in an uncluttered area. You
may want to secure the networking cables and switch power cord to the table
leg or other part of the surface structure to help prevent tripping over the
cords.
Caution
Make sure the air flow is not restricted around the sides and back of the switch.
5. Connect the Switch to a Power Source
1.
Plug the included power cord into the switch’s power connector and into
a nearby AC power source.
2.
Re-check the LEDs during self test. See “LED Behavior” on page 2-9.