HP LC2000r HP Netserver LC 2000 Installation Guide - Page 129
SCSI Configuration Utility
View all HP LC2000r manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 129 highlights
Chapter 10 Configuring the HP NetServer Open = Off Closed = On 2 Processor Speed (Bit 1) 3 Processor Speed (Bit 2) 4 Processor Speed (Bit 3) 5 Clear Configuration 6 Clear Password Shaded rectangle represents the position of slide switch. 8 FSB Speed (133/100 MHz) Rear of HP NetServer Figure 10-2. Configuration Switch Block - Clearing CMOS 3. Power up the HP NetServer. Refer to Chapter 2, "Controls, Ports, and Indicators." 4. Allow the HP NetServer to boot the operating system. 5. Shut down the operating system and power down the HP NetServer. Refer to Chapter 2, "Controls, Ports, and Indicators." 6. Reset switch 5 from On (closed) to Off (open) on the system board's configuration switch block. See Figure 10-2. 7. Replace the cover and power up the HP NetServer. Refer to Chapter 3, "Opening and Closing the HP NetServer." SCSI Configuration Utility If you need to verify or modify SCSI host adapter settings, or if you need to low-level format SCSI disks or verify SCSI disk media, run the Symbios Configuration utility: 1. Turn on or reboot your system. 2. During system start-up or reset, when the following message appears, press the [CTRL] and [C] keys at the same time. Press [Ctrl] [C] to start Symbios Configuration Utility 121