HP LC2000r HP Netserver LC 2000 Installation Guide - Page 165
th Hole, From Bottom, 14th Hole, Bottom of, NetServer, Rack Nuts
View all HP LC2000r manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 165 highlights
Chapter 13 Alternative Rack Mounting Attaching the Cable Management Arm Use this procedure to mount the Cable Management Arm on the HP NetServer LC 2000r when mounted in the HP System racks. The HP NetServer LC 2000r's Cable Management Arm allows the cables, including the power cord, to move in and out with the HP NetServer chassis without being accidentally disconnected. See Figure 13-10. WARNING Before sliding out the HP NetServer LC 2000r, ensure the anti-tip foot is still extended from the front of the rack. A tip-over hazard exists, so never slide more than one component out of the rack at a time. 1. Ensure the HP NetServer LC 2000r is pushed all the way into the rack. 2. At the rear of the HP NetServer, place rack nuts on the left column in the 12th and 14th holes above the baseline (bottom) of the NetServer. See Figure 13-10. Left Rear Rack Nuts 14th Hole From Bottom 12th Hole From Bottom Bottom of NetServer Figure 13-10. Attaching the Rack Nuts to the Left Column 3. Orient the cable management arm as shown in Figure 13-11. 4. Match the inner flange mounting holes with the two captive nuts at the rear of the NetServer. See Figure 13-11. 157