HP LC2000r HP Netserver LC 2000 Installation Guide - Page 57
If the drive is unseated in the cage after closing the ejector handle, repeat
View all HP LC2000r manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 57 highlights
Chapter 4 Installing Mass Storage Devices CAUTION Use caution when handling the drive to prevent damage to the fragile light pipes as you insert the drive. 5. Gently slide the drive module into the cage and stop when you feel resistance. See Figure 4-11. Figure 4-11. Inserting the Drive 6. Verify the pin behind the pivot end of the handle engages the hole in the edge of the cage. 7. Press the ejector handle in until you feel the latch click into place. Closing the ejector handle engages the drive with the electrical connector in the Hot Swap drive cage and seats the drive. 8. If the drive is unseated in the cage after closing the ejector handle, repeat this procedure from Steps 4 to 7. The handle was probably not pulled out far enough, and the locking latch failed to engage the Hot Swap mass storage cage. NOTE Closing the ejector handle engages the drive with the electrical connector in the Hot Swap mass storage cage and seats the drive. 49