HP LC2000r HP Netserver LC 2000 Installation Guide - Page 77
Refer to the accessory board documentation for connection requirements.
View all HP LC2000r manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 77 highlights
Chapter 6 1. Insert Board Installing Additional Boards 2. Close Latch 3. Turn Tab Figure 6-4. Installing the Accessory Board 12. Secure the PCI board as shown in Figure 6-4. 13. If the installed accessory board requires an external connection or a connection to the System board, ensure the cable is properly attached. Refer to the accessory board documentation for connection requirements. 14. If accessory board installation is complete, re-install the cover on the NetServer. Refer to Chapter 3, "Opening and Closing the HP NetServer." 15. Re-install the bezel onto the front of the HP NetServer. Refer to Chapter 3, "Opening and Closing the HP NetServer." 69
Chapter 6
Installing Additional Boards
69
1. Insert Board
2. Close Latch
3. Turn Tab
Figure 6-4. Installing the Accessory Board
12.
Secure the PCI board as shown in Figure 6-4.
13.
If the installed accessory board requires an external connection or a
connection to the System board, ensure the cable is properly attached.
Refer to the accessory board documentation for connection requirements.
14.
If accessory board installation is complete, re-install the cover on the
NetServer.
Refer to Chapter 3, "Opening and Closing the HP NetServer."
15.
Re-install the bezel onto the front of the HP NetServer.
Refer to Chapter 3, "Opening and Closing the HP NetServer."