HP LC2000r HP Netserver LC 2000 Installation Guide - Page 156
HP NetServer Rack Mount Parts List, Mounting Column Adapters
View all HP LC2000r manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 156 highlights
Chapter 13 Alternative Rack Mounting Preparing the Rack The column adapters and the slide mechanism must be connected to the rack before installing the HP NetServer LC 2000r into the rack. A cardboard rack-mounting template comes with the HP NetServer. This template shows you where to mount the column adapters and slides on the rack. HP NetServer Rack Mount Parts List Ensure the rack-mounting kit provided with the HP NetServer contains the following parts: Table 13-1. Parts for Rack Mount Kit Quantity 2 4 12 6 2 1 Description Slides Rack Nuts Rack Nut Screws (M5 x 16mm) Screws for Slides (8-32 x ¼ inch, 2 flathead, 4 panhead) Column Adapters Template Mounting Column Adapters Use this section to connect the two column adapters to the HP Systems rack, which are required for the Universal Bezel. The rack template and marking pen are used to identify and mark the locations for the column adapters. The column adapters attach to the front columns using the captive screws on the column adapters and don't require any rack nuts. CAUTION If other rack components are to be mounted in the rack below the HP NetServer, install those components before starting to mount the NetServer. NOTE Use the HP Rack Configuration Tools to determine where in the rack to mount the HP NetServer. 148