HP LC2000r HP Netserver LC 2000 Installation Guide - Page 73
Installing Accessory Boards
View all HP LC2000r manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 73 highlights
Chapter 6 Installing Additional Boards Open = Off Closed = On 2 Processor Speed (Bit 1) 3 Processor Speed (Bit 2) 4 Processor Speed (Bit 3) 5 Clear Configuration 6 Clear Password Shaded rectangle represents the position of slide switch. 8 FSB Speed (133/100 MHz) Rear of HP NetServer Figure 6-2. Configuration Switch Block Installing Accessory Boards Use this procedure to install all accessory boards. 1. Read the documentation included with each board and follow any special instructions provided. CAUTION To prevent a system crash, never remove or insert a PCI board from or into a slot with the NetServer powered on. Always turn power off to the NetServer before performing any installation or removal operations. 2. Log off all users and back-up all files. 3. Follow the instructions in the respective NOS (network operating system) documentation to gracefully shut down all networking software and applications. 4. Press the power button on the HP NetServer's control panel when prompted by the operating system. Normally, this completes the shutdown procedure. NOTE The power supplies will continue to provide standby current to the NetServer until the power cable is disconnected. 65