HP LC2000r HP Netserver LC 2000 Installation Guide - Page 145
Clearing the System Configuration
![]() |
View all HP LC2000r manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 145 highlights
Chapter 12 Troubleshooting ◊ Verify all DIMMs are HP-supplied and are seated properly. The boot screen provides information on the installed DIMMs. ◊ Verify all internal cabling and connections. ◊ If you have changed any switches on the system board, verify the switches are properly set. 5. Replace the cover and front bezel, and connect all cables. 6. Turn on the display and HP NetServer. 7. If the HP NetServer still does not work: ◊ Repeat steps 1, 2, and 3 of this section. ◊ Remove all accessories, except the primary boot hard disk drive. ◊ Replace the covers and connect all cables. ◊ Turn on the display and the HP NetServer. ◊ If the HP NetServer now works, replace the boards and accessories one at a time to determine which one is causing the problem. Clearing the System Configuration You may need to clear the system configuration if the configuration has been corrupted, or if incorrect settings made in the Setup Utility have made the display unreadable. Open = Off Closed = On 2 Processor Speed (Bit 1) 3 Processor Speed (Bit 2) 4 Processor Speed (Bit 3) 5 Clear Configuration 6 Clear Password Shaded rectangle represents the position of slide switch. 8 FSB Speed (133/100 MHz) Rear of HP NetServer Figure 12-1. System Switch Positions 137
![](/manual_guide/products/hewlettpackard-lh3000r-hp-netserver-lc-2000-installation-guide-748d8ad/145.png)