HP LC2000r HP Netserver LC 2000 Installation Guide - Page 54
Installing Hot Swap Hard Drives
View all HP LC2000r manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 54 highlights
Chapter 4 Installing Mass Storage Devices Installing Hot Swap Hard Drives Use this section to install Hot Swap hard drives in the Hot Swap drive cage. CAUTION Protect the drive from static electricity by leaving it in its anti-static bag until you are ready to install it. Before handling the drive, touch any unpainted metal surface to discharge static electricity. When you remove the drive from the anti-static bag, handle it only by the frame. Do not touch the electrical components. Place the drive on the anti-static bag whenever you set it down. 1. Unlock the Hot Swap Mass Storage Cage with the key provided before attempting to remove the drive spacer or filler panels. 2. Remove any filler panels in the desired disk drive location: a. Press in the locking latch and insert your fingers. b. Using your fingers, pull the filler plug straight out. See Figure 4-8. Figure 4-8. Removing Filler Panel from Cage 46