HP LC2000r HP Netserver LC 2000 Installation Guide - Page 61
Connecting External SCSI Devices
View all HP LC2000r manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 61 highlights
Chapter 4 Installing Mass Storage Devices Connecting External SCSI Devices The HP NetServer may provide an external SCSI connector (optional) at the rear panel knockout as shown in Figure 4-14. The external SCSI connector is typically connected to a PCI SCSI disk controller board inserted in one of the PCI slots. An external SCSI connection may also be provided by a SCSI disk controller board or a DAC board inserted into one of the PCI slots as shown in Figure 4-14. The last device in the SCSI chain of external devices must be terminated. See Figure 4-14. CAUTION Do not use high voltage differential (HVD) SCSI devices on any of the SCSI channels or damage will occur. The HVD SCSI devices are not supported. Use only Single-Ended (SE) or Low-Voltage Differential (LVD) devices to connect to the external connectors. SCSI Drive Controller Board (Optional) Figure 4-14. External SCSI Connection 53