HP LH4r HP Netserver LH 3/LH 3r to LH 4/LH 4r - Page 14

Upgrading the Rack LH 3r Configuration

Get HP LH4r - NetServer - 256 MB RAM PDF manuals and user guides View all HP LH4r manuals
Add to My Manuals
Save this manual to your list of manuals

Page 14 highlights

Chapter 1 Introduction Upgrading the Rack (LH 3r) Configuration You can upgrade the LH 3r rack configuration without removing it from the rack, but you may find it easier to reinstall the CPU baseboard and install the chassis reinforcement bars when the LH 3r is removed from the rack and sitting on a workbench. When in the rack, the chassis reinforcement bars mount on the bottom of the LH 3r. If you do decide to remove it from the rack to perform the upgrade, refer to the documentation below. CAUTION Do not pull the LH 3r forward in the rack without extending the anti-tip foot. If the anti-tip foot is not extended, the rack assembly can tip over and injure you and damage the NetServer or rack. For HP Racks Refer to the HP NetServer LH 3/LH 3r User Guide. For cabling instructions, refer to the documentation that came with the rack, and to the Rack Cabling Reference for the HP NetServer LH 4. For Non-HP (Compaq) Racks Refer to the HP NetServer LH 3r Installation Guide for Compaq® 4000/7000 Racks. For cabling instructions, refer to the documentation that came with the rack, and to the Rack Cabling Reference for the HP NetServer LH 4. 10

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
Chapter 1
Introduction
10
Upgrading the Rack (LH 3r) Configuration
You can upgrade the LH 3r rack configuration without removing it from the rack,
but you may find it easier to reinstall the CPU baseboard and install the chassis
reinforcement bars when the LH 3r is removed from the rack and sitting on a
workbench. When in the rack, the chassis reinforcement bars mount on the bottom
of the LH 3r. If you do decide to remove it from the rack to perform the upgrade,
refer to the documentation below.
CAUTION
Do not pull the LH 3r forward in the rack without extending
the anti-tip foot. If the anti-tip foot is not extended, the rack
assembly can tip over and injure you and damage the
NetServer or rack.
For HP Racks
Refer to the
HP NetServer LH 3/LH 3r User Guide.
For cabling instructions, refer
to the documentation that came with the rack, and to the
Rack Cabling Reference
for the HP NetServer LH 4.
For Non-HP (Compaq) Racks
Refer to the
HP NetServer LH 3r Installation Guide for Compaq
®
4000/7000
Racks.
For cabling instructions, refer to the documentation that came with the
rack, and to the
Rack Cabling Reference for the HP NetServer LH 4.