HP LH4r HP Netserver LH 3/LH 3r to LH 4/LH 4r - Page 25
Repeat steps 4 through 8 to install all DIMMs - two in one board, and two
View all HP LH4r manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 25 highlights
Chapter 3 Installing LH 4 Components 6. Align the notches on the DIMM with the keys in the slot (see Figure 3-7). Keys Notches Clips LEDs Figure 3-7. Inserting DIMMs into Memory Board 7. Hold the DIMM at a 90-degree angle to the system board. 8. Insert the DIMM carefully into the slot. The retaining clips will close automatically if it is inserted properly. CAUTION Do not rock the DIMM into place, but apply firm and even pressure directly downward. If the retaining clips do not close, remove the module and repeat steps 5 through 8. 9. Repeat steps 4 through 8 to install all DIMMs - two in one board, and two in the other board. CAUTION Do not install all four DIMMs into one board. Proper interleaving requires memory in each board, bank by bank. 21