HP LH4r HP Netserver LT 6000r Processor Upgrade Guide - Page 15
Setting the Processor Speed
View all HP LH4r manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 15 highlights
Chapter 1 HP NetServer LH 6000/6000r Processor Upgrade VRM 3 Locations 26 45 1 Figure 1-8. Inserting the VRM 3. If installing more processor modules, install a new VRM for each new processor module, by repeating Steps 1-2. Setting the Processor Speed If you are installing processors with a faster (or slower) speed setting than installed previously, you must change the switch settings of the configuration switch located on the system board. All processors in the system must operated at the same speed. 1. Determine the processor speed setting from Table 1-1. Table 1-1. Processor Module Speed Settings Processor Speeds SW 1 SW 2 SW 3 SW 4 550 MHz 600 MHz 650 MHz 700 MHz 750 MHz ON OFF OFF OFF OFF ON ON ON OFF ON ON OFF OFF ON OFF ON OFF ON OFF OFF 11