HP LH4r HP Netserver LT 6000r Processor Upgrade Guide - Page 31

3 BIOS Update Introduction This section applies to all HP NetServers described in this guide. After upgrading the processor module(s) or adding a processor module to a NetServer, the BIOS may require updating. Updating the BIOS After installing the new processor module(s), restart the NetServer from the HP NetServer Navigator CD-ROM provided with the new processor module. NOTE You are not required to use the HP NetServer Navigator CD-ROM to reconfigure your system after installing the new processor. The NetServer should detect the new or additional processors automatically. However, HP recommends using the HP NetServer Navigator CD-ROM provided with the processor upgrade kit to ensure you have the latest drivers and information. CAUTION Versions of the HP NetServer Navigator CD-ROM other than the one provided with the upgrade kit may not contain the appropriate BIOS for these new processor modules. Therefore, use only the HP NetServer Navigator CD-ROM provided with the upgrade kit, or a later version for the HP NetServers described in this guide. Perform the following instructions to ensure the BIOS is up-to-date. 1. Restart the NetServer with the HP NetServer Navigator CD-ROM provided with the processor upgrade kit inserted in the CD-ROM drive. When you restart the HP NetServer Navigator CD-ROM, you may see a message similar to the one listed below: 27