HP LH4r HP Netserver LT 6000r Processor Upgrade Guide - Page 28
See
View all HP LH4r manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 28 highlights
Chapter 2 HP NetServer LT 6000r Processor Upgrade 2. Gently insert the VRM into the desired slot. See Figure 2-8. VRM VRM Locations 3 2 6 45 1 Figure 2-8. Installing a VRM 3. If installing more processor modules, install a new VRM for each new processor module, by repeating Steps 1-2. Setting the Processor Speed If you are installing processors with a faster (or slower) speed setting than installed previously, you must change the switch settings of the configuration switch located on the system board. All processors in the system must operated at the same speed. 1. Determine the processor speed setting from Table 2-1. Table 2-1. Processor Module Speed Settings Processor Speeds SW 1 SW 2 SW 3 SW 4 550 MHz ON OFF OFF OFF 600 MHz OFF ON ON ON 650 MHz OFF ON ON OFF 700 MHz OFF ON OFF ON 750 MHz OFF ON OFF OFF 24