HP LH4r HP Netserver LT 6000r Processor Upgrade Guide - Page 29

Chapter 2 HP NetServer LT 6000r Processor Upgrade NOTE Some processor speeds listed in Table 2-1 and shown in Figure 2-9, may not be supported. For the latest support information, visit the HP web site: http:/www.hp.com/go/netserver. 2. Set the speed switches as listed in Table 2-1 and shown in Figure 2-9. A small, flat-blade screwdriver or similar tool may be used. ON 12345678 CPU Speed CPU Speed CPU Speed Clear Config Clear Password Recovery Boot Reserved OFF ON 1 2 3 4 OFF ON 1 2 3 4 OFF ON 1 2 3 4 OFF ON 1 2 3 4 OFF ON 1 2 3 4 550 Mhz 600 Mhz 650 Mhz 700 Mhz 750 Mhz Figure 2-9. Processor Switch Location (System Board) CAUTION Do not set the configuration switches to a different (faster) speed than the stated speed of the processor's design. All processors in the system must operate at the same speed. Setting the processor speed to another speed may result in unreliable or intermittent performance. Data integrity may also be placed at risk if processors are operated at speeds other than the one specified on the processor module. 25