HP LH4r HP Netserver LT 6000r Processor Upgrade Guide - Page 27

Latches open, Processor, Slot 1, Slot 2, Slot 3, Slot 4, Slot 5, Slot 6

Get HP LH4r - NetServer - 256 MB RAM PDF manuals and user guides View all HP LH4r manuals
Add to My Manuals
Save this manual to your list of manuals

Page 27 highlights

Chapter 2 HP NetServer LT 6000r Processor Upgrade Slot 3 Slot 2 Slot 1 Slot 6 Slot 5 Slot 4 Processor Latches open Figure 2-7. Inserting the Processor 5. Gently push down on the new processor until it is fully seated. See Figure 2-7. 6. Rotate the retaining latches to seat the processor firmly into the slot. 7. If installing more processor modules, repeat Steps 1-6 for each new processor module. 8. Close the access covers to the processor slots and tighten the thumbscrews. See Figure 2-4. Installing the VRM 1. Select the correct slot for the VRM and align it with the respective slot. NOTE The component side of the VRM will face down toward the system board. CAUTION Do not touch the VRM components as you push it into its slot. Use the edges of the VRM board to insert it into the slot. 23

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
Chapter 2
HP NetServer LT 6000r Processor Upgrade
23
Latches open
Processor
Slot 1
Slot 2
Slot 3
Slot 4
Slot 5
Slot 6
Figure 2-7. Inserting the Processor
5.
Gently push down on the new processor until it is fully seated.
See Figure 2-7.
6.
Rotate the retaining latches to seat the processor firmly into the slot.
7.
If installing more processor modules, repeat Steps 1–6 for each new
processor module.
8.
Close the access covers to the processor slots and tighten the thumbscrews.
See Figure 2-4.
Installing the VRM
1.
Select the correct slot for the VRM and align it with the respective slot.
NOTE
The component side of the VRM will face down toward the
system board.
CAUTION
Do not touch the VRM components as you push it into its slot.
Use the edges of the VRM board to insert it into the slot.