HP LH4r HP Netserver LT 6000r Processor Upgrade Guide - Page 24
Removing the Terminator
View all HP LH4r manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 24 highlights
Chapter 2 HP NetServer LT 6000r Processor Upgrade Removing the Terminator If your system has at least one processor module, there are terminators installed in all remaining slots. You must remove a terminator for each new processor before installing an additional processor module into the next available slot. 1. Loosen the thumbscrew and open the access cover to the processor slots. See Figure 2-4. Both sides of the processor cage have covers and thumbscrews. Processor Cage Thumbscrew Access Cover Figure 2-4. Removing the Access Cover 2. Open the latches and remove the terminator from the next available slot as shown in Figure 2-5. 20
Chapter 2
HP NetServer LT 6000r Processor Upgrade
20
Removing the Terminator
If your system has at least one processor module, there are terminators
installed in all remaining slots. You must remove a terminator for each
new processor before installing an additional processor module into the
next available slot.
1.
Loosen the thumbscrew and open the access cover to the processor slots.
See Figure 2-4.
Both sides of the processor cage have covers and thumbscrews.
Processor Cage
Thumbscrew
Access Cover
Figure 2-4. Removing the Access Cover
2.
Open the latches and remove the terminator from the next available slot as
shown in Figure 2-5.