HP Microportable Projector MP1800 MP1800 Microportable Projector - Page 12

Connecting the Projector to a Portable Computer, Powering On the Projector

Get HP Microportable Projector MP1800 PDF manuals and user guides View all HP Microportable Projector MP1800 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 12 highlights

Connecting the Projector to a Portable Computer 1. Rotate the elevator foot to balance the projector. 2. Connect one end of the projector signal cable to the projector and the other end to the VGA connector –B or the DFP connector –A on the portable computer and tighten the screws. ✎ Be sure the signal cable aligns with the connector. Do not force the cable onto the connector or you may damage the signal cable or the projector. 3. Connect one end of the power cord — into the back of the projector, and the other end to an electrical outlet that is easily accessible and close to the projector. 4. Turn on the projector first, then turn on the computer. Refer to the "Powering On the Projector" section later in this chapter for instructions on turning on the projector. ✎ For security purposes, this projector has been fitted with a security lock slot ˜ (located on the left, front side) for use with a security cable lock that can be purchased separately at most computer stores. 1-6 Getting Started

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
1-6
Getting Started
Connecting the Projector to a Portable Computer
1.
Rotate the elevator foot to balance the projector.
2.
Connect one end of the projector signal cable to the projector
and the other end to the VGA connector
➊
B
or the DFP
connector
➊
A
on the portable computer and tighten the screws.
✎
Be sure the signal cable aligns with the connector.
Do not force the cable onto the connector or you
may damage the signal cable or the projector.
3.
Connect one end of the power cord
➋
into the back of the
projector, and the other end to an electrical outlet that is easily
accessible and close to the projector.
4.
Turn on the projector first, then turn on the computer. Refer to
the
“
Powering On the Projector
”
section later in this chapter for
instructions on turning on the projector.
✎
For security purposes, this projector has been fitted
with a security lock slot
➌
(located on the left, front
side) for use with a security cable lock that can be
purchased separately at most computer stores.