HP Microportable Projector MP1800 MP1800 Microportable Projector - Page 59
Replacing the Projector Lamp, Multimedia Adapter speaker
View all HP Microportable Projector MP1800 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 59 highlights
Troubleshooting (continued) Problem A blue screen displays on the projection screen when a videocassette recorder is connected to the projector. Lamp shuts off Lamp burns out or makes a popping sound Multimedia Adapter speaker does not operate. Solution Check the videocassette recorder Play or TV/Video buttons. If that does not work, refer to your videocassette recorder manual. 1. If all five LEDs flash amber, the projector has overheated and will automatically shut down. Wait five to ten minutes until the LED buttons stop flashing and the Standby Button turns amber before restarting the projector again. 2. A minor power surge may cause the lamp to shut off. Wait a few minutes, then turn it back on. When the lamp reaches its end of life, it will burn out and may make a loud popping sound. If this happens, the projector will not turn back on until the lamp module has been replaced. Contact your local Compaq authorized dealer, seller, or reseller to purchase a replacement lamp module. To replace the lamp, follow the procedures in the "Replacing the Projector Lamp Module" section. 1. Make sure the audio cable is correctly connected to the Multimedia Adapter and the audio source. 2. Make sure the audio source is operating properly. 3. Make sure the Mute button is off. Continued A-4 Troubleshooting