HP Microportable Projector MP2810 Compaq MP2800 Microportable Projector - Page 59
Power on the projector., Wait about two minutes to allow the Flash Upgrade
View all HP Microportable Projector MP2810 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 59 highlights
Complete the following steps to upgrade the projector's ROM: 1. Connect one end of the cable to the DVI connector on the projector and the other end to the RS232 (serial) connector on the computer. 2. Power on the computer and monitor only (if applicable). 3. Access the Compaq website at: http://www.compaq.com 4. Follow the steps outlined on the website. 5. Power on the projector. 6. Wait about two minutes to allow the Flash Upgrade program to complete the upgrade, then the projector will automatically reset and be ready to use. Flash ROM Upgrade 59
Flash ROM Upgrade
59
Complete the following steps to upgrade the projector°s ROM:
1.
Connect one end of the cable to the DVI connector on the
projector and the other end to the RS232 (serial) connector
on the computer.
2.
Power on the computer and monitor only (if applicable).
3.
Access the Compaq website at:
4.
Follow the steps outlined on the website.
5.
Power on the projector.
6.
Wait about two minutes to allow the Flash Upgrade
program to complete the upgrade, then the projector will
automatically reset and be ready to use.