HP Mini 110-4100ca HP Mini 200 - Maintenance and Service Guide - Page 55
from the system board., Remove the keyboard
View all HP Mini 110-4100ca manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 55 highlights
7. Lift the rear edge of the keyboard (1), and then swing the keyboard (2) up and forward until it rests upside down on the palm rest. 8. Release the zero insertion force (ZIF) connector (1) to which the keyboard cable is attached, and then disconnect the keyboard cable (2) from the system board. 9. Remove the keyboard (3). Reverse this procedure to install the keyboard. Component replacement procedures 47
7.
Lift the rear edge of the keyboard
(1)
, and then swing the keyboard
(2)
up and forward until it
rests upside down on the palm rest.
8.
Release the zero insertion force (ZIF) connector
(1)
to which the keyboard cable is attached, and
then disconnect the keyboard cable
(2)
from the system board.
9.
Remove the keyboard
(3)
.
Reverse this procedure to install the keyboard.
Component replacement procedures
47