HP NV517UT Maintenance & Service Guide: Compaq 500B and 505B Minitower Bus - Page 16
Memory, DDR3-SDRAM DIMMs
UPC - 884962596715
View all HP NV517UT manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 16 highlights
Memory The computer comes with double data rate 3 synchronous dynamic random access memory (DDR3SDRAM) dual inline memory modules (DIMMs). DDR3-SDRAM DIMMs The memory sockets on the system board can be populated with up to two industry-standard DIMMs. These memory sockets are populated with at least one preinstalled DIMM. To achieve the maximum memory support, you can populate the system board with up to 4 GB of memory configured in a highperforming dual channel mode. For proper system operation, the DDR3-SDRAM DIMMs must be: ● industry-standard 240-pin ● unbuffered PC3-10600, 1333 MHz-compliant ● 1.5 volt DDR3-SDRAM DIMMs The DDR3-SDRAM DIMMs must also: ● support CAS latency 9 DDR3 1333 Mhz (9-9-9 timing) ● contain the mandatory JEDEC SPD information In addition, the computer supports: ● 512Mbit, 1Gbit, and 2Gbit non-ECC memory technologies ● single-sided and double-sided DIMMs ● DIMMs constructed with x8 and x16 DDR devices; DIMMs constructed with x4 SDRAM are not supported NOTE: The system will not operate properly if you install unsupported DIMMs. 8 Chapter 2 Removal and Replacement Procedures Microtower (MT) Chassis