HP NV517UT Maintenance & Service Guide: Compaq 500B and 505B Minitower Bus - Page 73
Power Button/Power Button LED, Using the Setup Utility - specs
UPC - 884962596715
View all HP NV517UT manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 73 highlights
For all other SKUs, Use F1 instead of F10 in the above handling. NOTE: If a device fails to respond while the BIOS tries to configure the device during POST, the BIOS must not make the system look as if it locked up by having an infinite loop or waiting for too long. Instead, the BIOS must time out after a reasonable amount of time (the time varies with the device) and skip to the next process. NOTE: Unless specified in this document as above, the BIOS should not stop the POST process with any POST diagnostic screen and/or error message to draw user's attention. For example, HP does not consider replacing a hard drive or CPU as an error condition. Power Button/Power Button LED The power button is under the BIOS control during POST, in BIOS Setup and after booting to a nonACPI OS. The BIOS must respond immediately when the power button is pressed in these environments. For the ACPI-compliant OS such as Windows, the BIOS must pass the power button information to the OS via the ACPI table as specified in the ACPI spec. If a platform offers a dual-color-based power button LED, the BIOS will program the power button LED to alternate the color between the On (ACPI S0) state and the Stand-by (S3) state. In doing so, the LED should not blink, but stay constant. Check with the corresponding platform manager for the default colors in the On and Stand-by states. The color of the power button LED in the Hibernate state (ACPI S4) is the same as in the S5 state. To find out if the system's power button LED is dual-color capable, check the SMBIOS Type 11 data structure. If the SMBIOS Type 11 data structure contains the string DLED (NOT case-sensitive), the system supports the dual-color power button LED and therefore, the BIOS support as described above is required. Using the Setup Utility The BIOS Setup Utility is accessed by pressing the F10 button during startup. The BIOS Setup Utility allows you to: ● Change factory default settings ● Set the system date and time ● Set, view, change, or verify the system configuration-including settings for graphics, audio, storage, communications, and input devices ● View processor and memory settings ● Modify the boot order of bootable devices-such as hard drives, diskette drives, optical drives, or USB media ● Run tests on the hard drive ● Establish a supervisor password that controls access to the Setup Utility Power Button/Power Button LED 65