HP Notebook 100 Compaq Armada 100S and Notebook 100 Series Maintenance and Ser - Page 91
Removing the System Board
View all HP Notebook 100 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 91 highlights
5. If installed, remove the RJ11 cover from the left side of the computer (Figure 5-32). 6. Disconnect the diskette drive LIF (low insertion force) cable from the system board . 7. Remove the system board from the base assembly . Figure 5-32. Removing the System Board IMPORTANT: When installing the system board, make sure the diskette drive cable does not get trapped underneath the system board. Removal and Replacement Procedures 5-35
Removal and Replacement Procedures
5-35
5. If installed, remove the RJ11 cover from the left side of the
computer
(Figure 5-32).
6. Disconnect the diskette drive LIF (low insertion force) cable from
the system board
.
7. Remove the system board from the base assembly
.
Figure 5-32.
Removing the System Board
IMPORTANT:
When installing the system board, make sure the diskette
drive cable does not get trapped underneath the system board.