HP Presario CQ43-300 Compaq Presario CQ43 Notebook PC Maintenance and Service - Page 51
Remove the Phillips PM2.0×3.0 screw, WLAN antenna cable is connected to the WLAN module Aux terminal.
View all HP Presario CQ43-300 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 51 highlights
2. Lift the rear edge of the memory module/wireless module compartment cover (2) up and forward until it rests at an angle. 3. Remove the memory module/wireless module compartment cover. The memory module/wireless module compartment cover is available in the Plastics Kit, spare part number 645981-001. 4. Disconnect the WLAN antenna cables (1) from the terminals on the WLAN module. NOTE: The #1 WLAN antenna cable is connected to the WLAN module Main terminal. The #2 WLAN antenna cable is connected to the WLAN module Aux terminal. 5. Remove the Phillips PM2.0×3.0 screw (2) that secures the WLAN module to the system board. (The WLAN module tilts up.) Component replacement procedures 43
2.
Lift the rear edge of the memory module/wireless module compartment cover
(2)
up and forward
until it rests at an angle.
3.
Remove the memory module/wireless module compartment cover. The memory module/wireless
module compartment cover is available in the Plastics Kit, spare part number 645981-001.
4.
Disconnect the WLAN antenna cables
(1)
from the terminals on the WLAN module.
NOTE:
The #1 WLAN antenna cable is connected to the WLAN module Main terminal. The #2
WLAN antenna cable is connected to the WLAN module Aux terminal.
5.
Remove the Phillips PM2.0×3.0 screw
(2)
that secures the WLAN module to the system board.
(The WLAN module tilts up.)
Component replacement procedures
43