HP Server rp7420 Installation Guide, Fifth Edition - HP 9000 rp7420 Server - Page 39

Unloading with Lift Handle Panels, Raising a Server Off the Pallet

Page 39 highlights

6. Slowly raise the server off the pallet until it clears the pallet cushions. Figure 2-8 Raising a Server Off the Pallet Unpacking the Server Unpacking a Non-Racked Server 7. Roll the lifter and server away from the pallet. Do not raise the server any higher than necessary when moving it over to the rack. NOTE When installing the system in a rack, refer to the HP J1530B Rack Integration Kit Installation Guide. Unloading with Lift Handle Panels WARNING Use this procedure only if an HP approved lift is not available. This procedure should only be attempted by two authorized HP service technicians. Before attempting this procedure, HP recommends that all cell boards and AC power supplies be removed. Instructions for removing these components can be found in the Removal and Replacement chapter of the service manual. Review local safety regulations before attempting to move the system, using the lift handle panels. Failure to observe these precautions can cause serious injury to personnel or damage to equipment. Chapter 2 39

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80

Chapter 2
Unpacking the Server
Unpacking a Non-Racked Server
39
6. Slowly raise the server off the pallet until it clears the pallet cushions.
Figure 2-8
Raising a Server Off the Pallet
7. Roll the lifter and server away from the pallet. Do not raise the server any higher than necessary when
moving it over to the rack.
NOTE
When installing the system in a rack, refer to the HP
J1530B Rack Integration Kit Installation
Guide
.
Unloading with Lift Handle Panels
WARNING
Use this procedure only if an HP approved lift is not available. This procedure
should only be attempted by two authorized HP service technicians.
Before attempting this procedure, HP recommends that all cell boards and AC power
supplies be removed. Instructions for removing these components can be found in
the Removal and Replacement chapter of the service manual. Review local safety
regulations before attempting to move the system, using the lift handle panels.
Failure to observe these precautions can cause serious injury to personnel or
damage to equipment.