HP Server rp7420 Installation Guide, Fifth Edition - HP 9000 rp7420 Server - Page 71
Accessing the Management Processor via a Web Browser, The ls Command Screen
View all HP Server rp7420 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 71 highlights
Cabling and Power Up MP Core I/O Connections 10. A screen similar to the following is displayed, allowing verification of the settings: Figure 4-9 The ls Command Screen To return to the MP Main Menu, enter ma. To exit the MP, enter x at the MP main menu. Accessing the Management Processor via a Web Browser Web browser access is an embedded feature of the MP. The Web browser allows access to the server through the LAN port on the core I/O card. MP configuration must be done from an ASCII console. NOTE The MP has a separate LAN port from the system LAN port. It requires a separate LAN drop, IP address, and networking information from that of the port used by HP-UX. Before starting this procedure, the following information is required: • IP address for the MP LAN • Subnet mask • Gateway address • Host name (this is used when messages are logged or printed) To configure the LAN port for a Web browser, perform the following steps: Step 1. Connect to the MP using a serial connection. Step 2. Configure the MP LAN. Refer to "Configuring LAN Information for the MP". Step 3. Type CM to enter the Command Menu. Chapter 4 71