HP Server rp7420 Installation Guide, Fifth Edition - HP 9000 rp7420 Server - Page 59
Power Source versus. Power Distribution, Power Source B
View all HP Server rp7420 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 59 highlights
Cabling and Power Up AC Input Power If two separate power sources are available, the two power supplies can be plugged into the separate power sources, increasing system reliability should one power source fail. Figure 4-2 Power Source versus. Power Distribution BPS 0 BPS 1 A0* A1* B0* B1* Power Source A Power Source B *180-269 VAC WARNING Voltage is present at various locations within the server whenever a power source is connected. This voltage is present even when the main power switch is in the OFF position. To completely remove power, all power cords must be removed from the server. Failure to observe this warning could result in personal injury or damage to equipment. NOTE System firmware prevents boot when a single power cord configuration is detected. Chapter 4 59