HP Slate 21-k100 HP Slate 21 All-in-One User Guide - Page 10

Setting up the hardware, Preparing for desk use, Preparing for wall mounting - vesa

Get HP Slate 21-k100 PDF manuals and user guides View all HP Slate 21-k100 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 10 highlights

2 Setting up the hardware You can install the all-in-one on a desktop or mount it to a mounting fixture such as a wall mount or swing arm. Be sure to place the all-in-one in a convenient, well-ventilated location. Connect the cables after you have installed the all-in-one to a mounting fixture. To set up the all-in-one, ensure that the power is turned off to the all-in-one and all attached accessories, and then follow the instructions below for your configuration. Preparing for desk use To assemble the all-in-one for desktop use: 1. Set the all-in-one face down on a flat, soft, protected table or desk surface. 2. Pull the stand outward until you hear it click. 3. Lift the all-in-one to an upright position and place on a flat, stable surface. Preparing for wall mounting NOTE: This all-in-one is intended to be supported by UL or CSA Listed wall mount bracket. You can only VESA mount the all-in-one in landscape orientation with the rear ports facing down. Do not place in portrait orientation. To attach the all-in-one to a mounting fixture: 1. Set the all-in-one face down on a flat, soft, protected table or desk surface. 4 Chapter 2 Setting up the hardware

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
2
Setting up the hardware
You can install the all-in-one on a desktop or mount it to a mounting fixture such as a wall mount or
swing arm. Be sure to place the all-in-one in a convenient, well-ventilated location. Connect the
cables after you have installed the all-in-one to a mounting fixture.
To set up the all-in-one, ensure that the power is turned off to the all-in-one and all attached
accessories, and then follow the instructions below for your configuration.
Preparing for desk use
To assemble the all-in-one for desktop use:
1.
Set the all-in-one face down on a flat, soft, protected table or desk surface.
2.
Pull the stand outward until you hear it click.
3.
Lift the all-in-one to an upright position and place on a flat, stable surface.
Preparing for wall mounting
NOTE:
This all-in-one is intended to be supported by UL or CSA Listed wall mount bracket.
You can only VESA mount the all-in-one in landscape orientation with the rear ports facing down. Do
not place in portrait orientation.
To attach the all-in-one to a mounting fixture:
1.
Set the all-in-one face down on a flat, soft, protected table or desk surface.
4
Chapter 2
Setting up the hardware