HP SlateBook 10-h010nr HP SlateBook 10 x2 PC Maintenance and Service Guide - Page 30
Display panel cable, Remove the Phillips PM2.0×2.0 screw
View all HP SlateBook 10-h010nr manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 30 highlights
3. Remove the Phillips PM2.0×2.0 screw (3) that secures the front webcam to the display assembly. 4. Remove the front webcam (4) and cable. Reverse this procedure to install the front webcam. Display panel cable NOTE: The display panel cable is included in the Display Panel Cable Kit, spare part number 728142-001. Before removing the display panel cable, follow these steps: 1. Turn off the tablet. If you are unsure whether the tablet is off or in Hibernation, turn the tablet on, and then shut it down through the operating system. 2. Disconnect the power from the tablet by unplugging the power cord from the tablet. 3. Disconnect all external devices from the tablet. 4. Remove the display enclosure (see Display enclosure on page 20). 5. Disconnect the battery cable from the system board (see Rear webcam on page 21). Remove the display panel cable: 1. Release the system board ZIF connector (1) to which the display panel cable is attached, and then disconnect the display panel cable from the system board. 2. Release the display panel ZIF connector (2) to which the display panel cable is attached, and then disconnect the display panel cable from the display panel. 24 Chapter 4 Removal and replacement procedures preliminary requirements