HP SlateBook 10-h010nr HP SlateBook 10 x2 PC Maintenance and Service Guide - Page 35

TouchScreen cable, Release the display panel ZIF connector

Get HP SlateBook 10-h010nr PDF manuals and user guides View all HP SlateBook 10-h010nr manuals
Add to My Manuals
Save this manual to your list of manuals

Page 35 highlights

TouchScreen cable NOTE: The TouchScreen cable is included in the Display Panel Cable Kit, spare part number 728142-001. Before removing the TouchScreen cable, follow these steps: 1. Turn off the tablet. If you are unsure whether the tablet is off or in Hibernation, turn the tablet on, and then shut it down through the operating system. 2. Disconnect the power from the tablet by unplugging the power cord from the tablet. 3. Disconnect all external devices from the tablet. 4. Remove the display enclosure (see Display enclosure on page 20). 5. Disconnect the battery cable from the system board (see Rear webcam on page 21). Remove the TouchScreen cable: 1. Release the system board ZIF connector (1) to which the TouchScreen cable is attached, and then disconnect the TouchScreen cable from the system board. 2. Release the display panel ZIF connector (2) to which the TouchScreen cable is attached, and then disconnect the TouchScreen cable from the display panel. 3. Detach the TouchScreen cable (3) from the battery. (The TouchScreen cable is attached to the battery with double-sided tape.) 4. Remove the TouchScreen cable (4). Reverse this procedure to install the TouchScreen cable. Removal and replacement procedures 29

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
TouchScreen cable
NOTE:
The TouchScreen cable is included in the Display Panel Cable Kit, spare part number
728142-001.
Before removing the TouchScreen cable, follow these steps:
1.
Turn off the tablet. If you are unsure whether the tablet is off or in Hibernation, turn the tablet on,
and then shut it down through the operating system.
2.
Disconnect the power from the tablet by unplugging the power cord from the tablet.
3.
Disconnect all external devices from the tablet.
4.
Remove the display enclosure (see
Display enclosure
on page
20
).
5.
Disconnect the battery cable from the system board (see
Rear webcam
on page
21
).
Remove the TouchScreen cable:
1.
Release the system board ZIF connector
(1)
to which the TouchScreen cable is attached, and then
disconnect the TouchScreen cable from the system board.
2.
Release the display panel ZIF connector
(2)
to which the TouchScreen cable is attached, and then
disconnect the TouchScreen cable from the display panel.
3.
Detach the TouchScreen cable
(3)
from the battery. (The TouchScreen cable is attached to the
battery with double-sided tape.)
4.
Remove the TouchScreen cable
(4)
.
Reverse this procedure to install the TouchScreen cable.
Removal and replacement procedures
29