HP Spectre 13-3018ca HP Spectre 13 Ultrabook - Maintenance and Service Guide - Page 51
Remove the heat sink
View all HP Spectre 13-3018ca manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 51 highlights
Remove the heat sink: 1. Loosen the 4 captive Philllips screws (1) - (4) that secure the heat sink to the system board, and then remove the heat sink (5). 2. The following illustration shows the replacement thermal material locations on a computer model equipped with a graphics subsystem with discrete memory. NOTE: The thermal material must be thoroughly cleaned from the surfaces of the heat sink and the system board components each time the heat sink is removed. Replacement thermal material is included with the heat sink and system board spare part kits. Thermal grease is used on the processor (1) and the heat sink section (2) that services it Component replacement procedures 43
Remove the heat sink:
1.
Loosen the 4 captive Philllips screws
(1)
–
(4)
that secure the heat sink to the system board, and
then remove the heat sink
(5)
.
2.
The following illustration shows the replacement thermal material locations on a computer model
equipped with a graphics subsystem with discrete memory.
NOTE:
The thermal material must be thoroughly cleaned from the surfaces of the heat sink and
the system board components each time the heat sink is removed. Replacement thermal material is
included with the heat sink and system board spare part kits.
Thermal grease is used on the processor
(1)
and the heat sink section
(2)
that services it
Component replacement procedures
43