HP StorageWorks 2/8-EL SAN Switch 2/8 V3.1.x - Installation Guide - Page 35
Connecting the power cord, 32 x 5/8 inch screws Item 5 and two retainer nuts Item 6.
![]() |
View all HP StorageWorks 2/8-EL manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 35 highlights
Installing the SAN Switch 2/8 7. Attach the rear brackets to the front brackets as follows: a. Position the right rear bracket (Item 4) inside the right front bracket (Item 8). See Figure 6. b. Secure the brackets using four 6-32 x 5/16 inch screws (Item 3). See Figure 6. c. Adjust the brackets to the appropriate rack depth and tighten screws to a torque of 9-inch pounds. 8. Repeat Steps 7a through 7c to attach the left rear bracket (Item 2) to the left front bracket (Item 1). 9. Attach the right rear bracket (Item 4) to the right rear rack rail using two 10-32 x 5/8 inch screws (Item 5) and two retainer nuts (Item 6). 10. Repeat step 9 to attach the left rear bracket (Item 2) to the left rear rack rail. 11. Tighten all screws to a torque of 25-inch pounds. 12. Connect the SAN Switch 2/8 power cord to the power connector on the switch. See Figure 7. Figure 7: Connecting the power cord SAN Switch 2/8 Version 3.1.x Installation Guide SHR-2496B 35
![](/manual_guide/products/hewlettpackard-storageworks-28el-san-switch-28-v31x-installation-guide-08d8150/35.png)