HP StorageWorks 2/8-EL SAN Switch 2/8 V3.1.x - Installation Guide - Page 53
Assembling the inner rails on a SAN Switch 2/8 with plenum, For the SAN Switch 2/8
![]() |
View all HP StorageWorks 2/8-EL manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 53 highlights
Installing the SAN Switch 2/8 5. For the SAN Switch 2/8, assemble the two inner rails (one on each side) to the switch and plenum using fourteen #8-32 x 3/16-inch Phillips pan-head screws as shown in Figure 20. Caution: Do not use any other screws other than the fourteen that are provided. Use of any longer lengths can cause damage to internal components Note: Verify that the plenum (part number A7346-00001) is preinstalled on the SAN Switch 2/8 before proceeding. The plenum is required for the SAN Switch 2/8 rack mount only, as it allows air to dissipate at the rear of the rack, preventing overheating. If the plenum shipped as a separate item, refer to Installing the Switch in the Optional HP System/e Rack, step 5, for complete plenum installation instructions. Figure 20: Assembling the inner rails on a SAN Switch 2/8 with plenum SAN Switch 2/8 Version 3.1.x Installation Guide 53
![](/manual_guide/products/hewlettpackard-storageworks-28el-san-switch-28-v31x-installation-guide-08d8150/53.png)