HP StorageWorks 4/64 Brocade Fabric OS Command Reference Manual (53-1000240-01 - Page 424
perfAddEEMonitor, This command is not supported on virtual FC ports VE/VEX_Port, EX_Port
View all HP StorageWorks 4/64 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 424 highlights
2 Note: Enter commands in lowercase only; mixed case is for readability. perfAddEEMonitor perfAddEEMonitor Adds an end-to-end monitor to a port. Synopsis perfaddeemonitor [slotnumber/]portnumber SourceID DestID Description Use this command to add an end-to-end performance monitor to a port. The performance monitor counts the number of words received, number of words transmitted, and number of CRC errors detected using either of the following two conditions: • For frames received at the port, the frame SID is the same as SourceID and frame DID is the same as DestID, both RX_COUNT and CRC_COUNT will be updated accordingly. • For frames transmitted from the port, the frame DID is the same as SourceID and frame SID is the same as DestID, both TX_COUNT and CRC_COUNT will be updated accordingly. To monitor traffic from host A to device B, add a monitor on port 2, specifying 0x050200 as the SID and 0x010100 as the DID. The RX count equals the number of words from host A to device B, whereas the TX count equals the number of words from device B to host A. The CRC count equals the total number of CRC errors for both directions. Adding a monitor on port 1, specifying 0x010100 as SID and 0X050200 as the DID has a similar effect, except the RX and TX counts are interchanged. If ISL monitoring is enabled, end-to-end monitors cannot be added to E_Ports. Existing end-to-end monitors on E_Ports are deleted. Identical monitors cannot be added to the same port. Two monitors are considered identical if they have the same SID and DID values after applying the end-to-end mask. After a successful execution of this command, a monitor number is displayed. The monitor number is provided for manipulation of these performance monitors. Note This command requires a Brocade Advanced Performance Monitoring license. This command is not supported on virtual FC ports (VE/VEX_Port), EX_Port, M (Mirror) ports and GbE ports. Note The execution of this command is subject to Admin Domain restrictions that may be in place. 2-390 Fabric OS Command Reference Manual Publication Number: 53-1000240-01