HP StorageWorks 4/64 Brocade Fabric OS Command Reference Manual (53-1000240-01 - Page 470
portCfg, Synopsis, Description, Entities
View all HP StorageWorks 4/64 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 470 highlights
2 Note: Enter commands in lowercase only; mixed case is for readability. portCfg portCfg Enables or disables a port's configuration. Synopsis portcfg action [slot/][ge]port args Description Use this command to configure the gigabit Ethernet (GbE) port, address resolution protocol (ARP) entries, IP interfaces on the gigabit Ethernet (GbE) port, static routes on the IP interface, FCIP tunnels, mirror port, and registered state change notification (RSCN) suppression. RSCN suppression is configurable for both FC and GbE ports; however, configuration options are dependent on the protocol. Note The execution of this command is subject to Admin Domain restrictions that may be in place. Entities This command operates on the following entities: arp ARP entries. Usage: portcfg arp [slot/][ge]port args. Valid args for arp are: • add ipaddr macaddr Adds static ARP entries. • delete ipaddr Deletes static ARP entries. • flush Flushes the ARP table. fciptunnel FCIP tunnels. Usage: portcfg fciptunnel [slot/][ge]port args [optional_args]. Valid args for fciptunnel are: • create tunnel_id remote_ipaddr local_ipaddr comm_rate Creates FCIP tunnels. optional_args for create include: -c Enables compression on the tunnel specified. -f fastwrite Enables fastwrite on the tunnel specified. This argument cannot be used together with -ike, -ipsec or -key (IPSec). -ike policy Specifies the IKE policy number to be used on the tunnel specified. This argument must be used together with -ipsec and -key. This argument cannot be used together with -f (fastwrite) or -t (tape pipelining). -ipsec policy Specifies the IPSec policy number to be used on the tunnel specified. This argument must be used together with -ike and key. This argument cannot be used together with -f (fastwrite) or -t (tape pipelining). -k timeout Specifies the keep alive timeout, in seconds. timeout values are 8 to 7,200; default is 10. If tape pipelining is enabled, minimum value supported is 80. 2-436 Fabric OS Command Reference Manual Publication Number: 53-1000240-01