HP StorageWorks 4/64 Brocade Fabric OS Command Reference Manual (53-1000240-01 - Page 485
portCfgLongDistance, Operands, Examples, See Also
View all HP StorageWorks 4/64 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 485 highlights
Note: Enter commands in lowercase only; mixed case is for readability. portCfgLongDistance 2 Operands Examples This command has the following operands: slotnumber Specifies the slot number, for bladed systems only. The slot number must be followed by a slash (/). portnumber Specifies a port number. Valid values for port number vary, depending on the switch type. Use switchShow to display a list of valid ports. This operand is required. distance_level Refer to the "Description" section for information about the value. vc_translation_link_init Specifies the long-distance link-initialization sequence; 1 activates and 0 deactivates this mode. When the command is run without specifying a value, 1 is assigned automatically for the long-distance link in VC_RDY flow control; otherwise, 0 is assigned. This operand is optional. desired_distance Refer to the "Description" section for information about the value. To configure a switch port 63 to support a 100 Km link and be initialized using long-distance link initialization protocol: switch:admin> portcfglongdistance 4/15 LS 1 100 switch:admin> portshow 4/15 portCFlags: 0x1 portFlags: 0x20001 PRESENT LED portType: 1.1 portState: 2 Offline portPhys: 4 No_Light portScn: 0 portId: 013f00 portWwn: 20:3f:00:60:69:00:02:48 Distance: super long