HP StorageWorks 4/64 Brocade Fabric OS Command Reference Manual (53-1000240-01 - Page 472
Creates IP routes.
View all HP StorageWorks 4/64 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 472 highlights
2 Note: Enter commands in lowercase only; mixed case is for readability. portCfg Operands ipif iproute rscnsupr Specifies the maximum retransmissions for the existing tunnel. retransmissions values are 1 to 16; default is 8. If tape pipelining is enabled, default value is calculated based on the mininum retransmit time to ensure that tcp connection does not timeout before the host times out. If the user changes this value, the value specified must be greater than the calculated value. -s 0|1 Disable (0) or Enable (1) selective acknowledgement (SACK) on the existing tunnel. -t 0|1 Disable (0) or Enable (1) tape pipelining on turned on as well). • delete tunnel_id Deletes FCIP tunnels. IP interface entries. Usage: portcfg ipif [slot/][ge]port args. Valid args for ipif are: • create ipaddr netmask mtu_size Creates IP interfaces. • delete ipaddr Deletes IP interfaces. IP route entries. Usage: portcfg iproute [slot/][ge]port args. Valid args for iproute are: • create ipaddr netmask gateway_router metric Creates IP routes. • delete ipaddr netmask Deletes IP routes. Manages RSCN suppression on the local port. Usage: portcfg rscnsupr [slot/ ][ge]port args. Valid args for iproute are: • -range Specifies a range of ports in the same slot to apply the configuration to. • --disable Disables the configuration. When disabled, device changes on the port generates RSCN to another end device that is zoned with this one. By default, RSCN suppression is disabled to all ports. • --enable Enables the configuration. When enabled, any device change on the port does not generate RSCN to any other end device. This command has the following operands: slot For bladed systems only, specifies the slot number of the port to be configured, followed by a slash (/). port Specifies the number of the ports to be configured, relative to its slot for bladed systems. For GbE ports, the ports are numbered ge0 and ge1. Use switchShow for a list of valid ports. ipaddr Specifies the interface protocol as IP and the IP address on the GbE port. Use this 2-438 Fabric OS Command Reference Manual Publication Number: 53-1000240-01