HP StorageWorks 8/20q HP StorageWorks 8/20q Fibre Channel Switch command line - Page 148
set log, hardreset, hotreset, Table 22, The default values are shown
![]() |
View all HP StorageWorks 8/20q manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 148 highlights
switch Resets the switch without a power-on self test (POST). This is the default. This reset disrupts traffic and does the following: • Activates the pending firmware • Closes all management sessions • Clears the event log. To save the event log before resetting, see the "set log" on page 171. To reset the switch with a power-on self test, see the "hardreset" on page 132. To reset the switch without disrupting traffic, see the "hotreset" on page 135. NOTE: The following files are deleted from the switch during a switch reset: • Firmware image files that have not been unpacked • Configuration backup files • Support files system Resets the system configuration settings to the factory default values as described in Table 22. NOTE: Because this operand changes network parameters, the workstation could lose communication with the switch. This operand does not affect installed license keys. zoning Clears the zoning database and deactivates the active zone set. The zoning configuration parameters (MergeAutoSave, DefaultZone, DiscardInactive) remain unchanged. See Table 18 for information about the zoning configuration parameters. Notes The following tables specify the various factory default settings: • Enter the show setup callhome command to display the Call Home database configuration. The default values are shown in Table 14. • Enter the show config switch command to display switch configuration. The default values are shown in Table 15. • Enter the show config port command to display port configuration. The default values are shown in Table 16. • Enter show config threshold command to display port threshold alarm configuration. The default values are shown in Table 17. • Enter the show config zoning command to display zoning configuration. The default values are shown in Table 18. • Enter the show setup snmp command to display SNMP configuration. The default values are shown in Table 19. • Enter the show setup radius command to display RADIUS configuration. The default values are shown in Table 20. • Enter the show setup services command to display switch service configuration. The default values are shown in Table 21. • Enter the show setup system command to display system configuration. The default values are shown in Table 22. • Enter the show config security command to display security configuration. The default values are shown in Table 23. 148 Command reference
![](/manual_guide/products/hewlettpackard-ak241a-hp-storageworks-820q-fibre-channel-switch-command-line-interface-guide-56977198-2008-f6c9aa2/148.png)