HP StorageWorks 8/20q HP StorageWorks 8/20q Fibre Channel Switch command line - Page 183
set setup snmp, Table 42 SNMP configuration settings, SNMPEnabled, False, Contact, Location, Address
![]() |
View all HP StorageWorks 8/20q manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 183 highlights
set setup snmp Description Configures SNMP on the switch. Authority Admin session Syntax set setup snmp Prompts you in a line-by-line fashion to change SNMP configuration settings. Table 42 describes the SNMP configuration parameters. For each parameter, enter a new value or press Enter to accept the current value shown in brackets. Table 42 SNMP configuration settings Parameter SNMPEnabled Contact Location Trap [1-5] Address Trap [1-5] Port Trap [1-5] Severity Trap [1-5] Version Trap [1-5] Enabled ReadCommunity WriteCommunity TrapCommunity Description Enables (True) or disables (False) SNMP on the switch. The default is True. Specifies the name of the person to be contacted to respond to trap events. The name can be up to 64 characters excluding #, semicolon (;), and comma (,). The default is undefined. This value is also passed to the Call Home service configuration. Specifies the name of the switch location. The name can be up to 64 characters excluding #, semicolon (;), and comma (,). The default is undefined. This value is also passed to the Call Home service configuration. Specifies the workstation IP address to which SNMP traps are sent. The default address for trap 1 is 10.0.0.254. The default address for traps 2-5 is 0.0.0.0. Addresses, other than 0.0.0.0, for all traps must be unique. Specifies the workstation port to which SNMP traps are sent. Valid workstation port numbers are 1-65535. The default is 162. Specifies the severity level to use when monitoring trap events. The default is Warning. Specifies the SNMP version (1 or 2) to use in formatting traps. The default is 2. Specifies whether traps (event information) are enabled (True) or disabled (False). The default is False. Read community password that authorizes an SNMP agent to read information from the switch. This is a write-only field. The value on the switch and the SNMP management server must be the same. The read community password can be up to 32 characters excluding #, semicolon (;), and comma (,). The default is public. Write community password that authorizes an SNMP agent to write information to the switch. This is a write-only field. The value on the switch and the SNMP management server must be the same. The write community password can be up to 32 characters excluding #, semicolon (;), and comma (,). The default is private. Trap community password that authorizes an SNMP agent to receive traps. This is a write-only field. The value on the switch and the SNMP management server must be the same. The trap community password can be up to 32 characters excluding #, semicolon (;), and comma (,). The default is public. 8/20q Fibre Channel Switch command line interface guide 183
![](/manual_guide/products/hewlettpackard-ak241a-hp-storageworks-820q-fibre-channel-switch-command-line-interface-guide-56977198-2008-f6c9aa2/183.png)